The Speedpuls may only be installed by qualified personnel and at the user's own risk.

Neither the manufacturer nor the dealer can be held liable for defects resulting from incorrect installation or improper use.

1. Removing the instrument panel
2. Remove the cover of the Gala installation opening on the speedometer by means of predetermined breaking points, if available
3. Insert module and slide it towards the speedometer cable as far as it will go and screw it tight.
4. Turn the speedometer shaft drive with a small screwdriver and listen for grinding noises. If necessary, place the enclosed washers under the module. Also, the LED should start flashing when turning.
5. The tachometer needle should move back to its zero position on its own and without resistance.
6. If this is not the case, the sensor tip can be corrected in the direction of the speedometer shaft by applying a slight amount of heat, e.g. a hair dryer. ATTENTION: DO NOT use hot air blowers or burners!
7. Reassemble instrument carrier

Optionally the output level can be adjusted to 12V (e.g. for TDI control units). Connect the open solder bridge for this purpose.