Differences

This shows you the differences between two versions of the page.

--- tachoplatine:speedometer_board_mk3 [2024/01/12 07:07] – [Troubleshooting] brun
+++ tachoplatine:speedometer_board_mk3 [2025/06/17 18:01] (current) – brun
@@ Line 129: / Line 129: @@
 === Terminal assignment with Tachometer ===
-{{ tachoplatine:oeldruckkontrolle_umschalten.jpg?600 |}}
+{{ tachoplatine:anschlussbelegung_dzm.jpg?600 |}}
 === Terminal assignment with analog clock or without clock ===
@@ Line 210: / Line 210: @@
 Then the spacer and the cable are mounted. The spacer should already be mounted. Without it, unnecessary pressure is exerted on the circuit board and it can be damaged.
 {{ tachoplatine:tachoplatine_ausgebaut.jpg?direct&600 |}}
@@ Line 290: / Line 291: @@
 Solution: There will be nothing left but to check the electrical system.
-==== Closing words ====
+===== Closing words =====
-Finally, I wish you success and a lot of fun during assembly and always an accident-free and mishap-free ride.the speedometer light with the dynamic oil pressure control is confused. This can otherwise lead to damage.
+Finally, I wish you success and a lot of fun during assembly and always an accident-free and mishap-free ride.